English
  • English
Your position:Home> News>One hump hose news>silicone hump hose

silicone hump hose

From:Xiamen Hosingtech Auto Parts Co., Ltd     Release time:2018-09-14

Overview:Fabric, polyester fabric four-layer sanitary hose, double-layer silicone tube 304 stainless steel wire, spacing 10MM, sanitary hose inner wall transparent and smooth, outer wall, transparent and smooth sanitary hose, sanitary grade steel hose features smooth hose. Both the outer wall and the pleated outer wall can be used, and the low decomposition rate food silicone tube is suitable for use in pharmaceutical, biomedical, cosmetic and food processing.

High temperature resistant silicone tube features:

1. Fabric, polyester fabric four-layer sanitary hose, double-layer silicone tube 304 stainless steel wire, spacing 10MM, sanitary hose inner wall transparent and smooth, outer wall, transparent and smooth sanitary hose, sanitary grade steel hose features smooth hose. Both the outer wall and the pleated outer wall can be used, and the low decomposition rate food silicone tube is suitable for use in pharmaceutical, biomedical, cosmetic and food processing.

2. The inner tube is made of high-purity platinum vulcanized silica gel material with hardness of 70A. It can be used for complete vacuum bottom, anti-cracking, kink-resistant, durable, withstand pressure, translucent and visually monitor the flow of the medium. Because the whole process is manual operation, some glued products have too much glue to absorb the beauty of the product itself, and the pulling force is not enough.

3. Available in two types, smooth outer wall or pleated outer wall for higher elasticity, the usual operating temperature range.

During assembly, if the amount of crimping is too small, that is, when the joint between the joint and the hose is too loose, the hose may be released from the joint at the initial stage of use due to the oil pressure; if the crimping amount is too large, the joint and the hose are pressed. Too tight, it is easy to cause partial damage to the inner layer of the hose, resulting in cracks. The high-pressure oil will directly enter the wire layer from the rupture, and then squirt along the gap between the wires to the tail of the jacket, or accumulate somewhere along the wire layer. So that the outer layer of glue produces a bulge or even rupture. When the hose and the joint are assembled, if the pressing speed is too fast, the inner rubber is damaged and the steel layer is broken, so that the hose is damaged prematurely during use.


Tags
Message BoardPlease write down your question and we will respond to you within 24 hours.